NOTICE: Most tools are extremely difficult to find since these were provided only

                 to the dealers to purchase.

                 Because of this, some tools can only be obtained from old dealer service departments.

                 Most tools were discontinued being made by the manufacturers.

#0276-150-005 -     $27
           Magneto puller for Bosch and

           Motoplat  external flywheels

  26mm medium threads

  external Motoplat flywheel shown in photo

#0276-150-100 -     $27 ea
           Magneto puller for 

           Motoplat  internal flywheels

  27mm fine threads

  internal Motoplat flywheel shown in photo

 - #99-30-202 -            $3 ea
           Hi-Point swing arm wrench for 1973+ Penton swing arms with needle bearings
 

  #0276-065-101  -     Sold out

     wrist pin extractor

A

B

C

D

  Inserts fit onto end of extractor to fit wrist pin diameter

A  #0276-122-011  - 11.8mm O.D. -   Sold out

B  #0276-122-013  - 13.8mm O.D. -     $11 ea

        for 100/ 125/ 175 piston wrist pins

C  #0276-122-017  - 17.8mm O.D. -     $11 ea

        for 250/ 400/ 420/ 495 piston wrist pins

D  #0276-122-021  - 21.2mm O.D. -     $11 ea

  Inserts through piston to line piston up on rod prior to inserting

  the wrist pin, 2" long - slightly smaller diam. for easy insertion.

   #0977-053-000  -  $2 ea

A

B

A- #0676-027-000 -           $10 ea
        extractor for Sachs brass wrist pin bushing

B- #0276-135-000 -         Sold out
        timing gauge for ignition advance on Bosch and Motoplat     

        fit on ends of rods to guide them through holes when

        fitting case halves together

  #54-34-PINS -   sold out

  #2876-007-000 -  $3 ea

    Twin flat blade screw driver - small & tiny blades

    great for Bosch and Motoplat timing adjustements

     #1476-011-000 -       Sold out

A

B

C

D

   Jaws for Bearing Puller

   split jaws fit over puller #1476-011-000 and bearing

    and are locked in place with clamp ring

    Bearing end has thin lip to grab outer bearing edge

A  #JAWS-33  - fits M25 & NJ205 bearings    Sold out 

B  #JAWS-36  - fits NJ305 bearings        Sold out 

C  #JAWS-39  - fits NJ206 bearings        Sold out 

D  #1437-009-000  - clamping ring, 58mm I.D.     Sold out 

   Bearing puller with assorted selection of 16 jaws

   includes 3 clamping rings 58mm / 75mm / & 85mm

   includes jaws for E15/ BO17/ & M25 crank bearings

    #1476-011-KIT  - bearing puller kit.      Sold out