PREVIOUS PAGE HOME PAGE ORDERING INFO
SEAT PARTS
for 100-125cc
PENTON / KTM motorcycles
COVERS / FOAM / BASES / HARDWARE
Call: Al Buehner - (216) 651-6559 Mon-Fri 8:30am to 4pm E.S.T.
or e-mail us a list of your quantities and part numbers pentonpartsusa@sbcglobal.net
(NOTE: parts are available only while supplies last - prices subject to change without notice)
Steel Tanker SEAT COVERS
#5-23-100 Sold Out long seat cover for 1969-1971 bikes
Close-out SPECIAL - white lettering flaked off leaving grey Penton lettering as shown #5-23-100-xx - close-out $48 each
|
|
photo of short/ tall cover |
CMF SEAT COVERS
short/tall for 1974 with “PENTON/KTM” logo back section measures aprox. 3-1/2" from inside curve to top seam
long/tall for 1975 with “PENTON/KTM” logo made in USA |
Short/ low seat foam |
SEAT FOAM
short/low for 1972/73, 18” long
back section measures 2-1/2" from inside curve to top edge |
Short & Long/ tall seat foam |
SEAT FOAM
#51-07-042-100 – $120 ea short/tall for 1974, 18” long across top #51-07-042-200 - $120 ea long/tall for 1975, 21” long across top made in USA back section measures aprox. 3 to 3-1/4" from inside curve to top edge |
photo of short seat base made in USA |
FIBERGLASS BASES
short, 19” long (measured along side from front to back) side seat
trim have 2 mounting screws & nuts long, 21” long (measured along side from front to back) side seat trim have 3 mounting screws & nuts |
A
B
C E
D made in USA |
SEAT HARDWARE
Stainless steel front seat bracket, x-long B - #51-07-044-000 - sold out Stainless steel front seat bracket
Stainless steel rear seat bracket
short seat trim, aluminum long seat trim, aluminum NOTE: not for use on steel tanker seats (not long enough) |
Have a question about which part is right for your bike? Are you ready to place an order?
Call: Al Buehner - (216) 651-6559 Mon-Fri 8:30am to 4pm E.S.T. e-mail - pentonpartsusa@sbcglobal.net or Fax us a list of your quantities and part numbers: 216-651-1620 |